Columbus Ohio Gay Cruising Areas

MYOG Dosenkocherbau

So
of recent events there's again a little instruction. Today on 'canned homemade kettle'.

Ingredients:

- 2 empty and 1 full 250ml beverage can
- 2-component adhesive

tool:
- Cutter blade
- "spacers"
- punch
- half-round file, fine
- sandpaper or fluid

is first the first box cut 35mm off the ground. For this, the blade is attached to a spacer (piece of wood, book ...), easy to box pressed and the shot. watch out for all work that the can is not pushed!


can be pressed, the sheet after a few cautious laps.


now is deburred inside and pushed the part about 5mm above the bottom of the box full. She widens slightly. In the bottom of the can, we now need a big hole punch from the inside out. For this one can take a tube that you anschleift around ca.25mm-diameter (last picture).


Then the second box is about 10mm from the ground floor around. Then, the stuck together more easily. Then is cut from a can rest piece is 38mm wide band. This is then cut at a right angle to 161mm (if I remember correctly ...). Now is 5 mm from both ends of the strip opposite folded. This is then used to push together as a rebate.



come into the band now eight holes with a distance of 18.25mm, then it is put together. The ring should fit into the fold of the lower box (size 146mm).


Well, now comes a tricky part. Maybe someone has another idea, too ...
And although you have to build something like this now:


When I construct a steel tube, 6mm, that was sharpened (or better drilled with a countersink) was pressed into a hole in a wooden barrel. So I can punch the holes without eindellt the box. We again need
8 holes, with 20.75 mm distance (circumference 166mm)

Finally, the fold of the lower box and the fold of the ring with 2-smeared glue, the ring is inserted and the top box is cautious about the bottom (ground) can, until they can not be pushed together further.


Sødal ... Now you have a 8gr doses cooker. Advantage of this Kocherart to Sideburnern in Verl calibration is that the central flame rises to the top. The increases the efficiency of small diameter boiler erhäblich!

Have fun recreating.

your Knilch